wonfor

  1. ColinWonfor

    The NEW EWA A40 made by Paul Quick

    The workmanship Paul does is amazing, The Amp runs 18W Class A the A/B upto 60W/ch 8R From right to left:- Power Isolation Switch, Push for instant start and timed out about 1Hr with no music playing, Toggle Switch centre trigger-Up OFF - Down away ON Switch Toggle on back is for Balance or...
  2. ColinWonfor

    The new M40 SECA DRIVE power AMP

    Here is the block diagram comments please. And I do draw badly .
  3. ColinWonfor

    DC Blocker Plus

    Here FOC a DC Blocker Plus a Few odd Bits. And Gerber Files enjoy.
  4. ColinWonfor

    50W TOCA SECA

    The only pair of 50W TOCA SECA in the world, at home in the SW of England.
  5. ColinWonfor

    LS 25 and LS40 and the LS80 on public run.

    See Pinkfish for coments. EWA LS80 speaker cables Elsdon Wonfor Audio LS-40 speaker cables Elsdon Wonfor Audio LS-25 speaker cables Next question are you all well ??, just had my jab here, But the cold has made my bones hurt.
  6. ColinWonfor

    The New M50A

    The M50A is biased to 35W Class sliding to A/B. The heatsink is the chassis and temperature controlled not to go above 40C (unless you are already at 40C), So in a home at 25C the max temp was 37.8C On start up the idle current is set to be twice the running current so the M50A quickly get to it...
  7. ColinWonfor

    Mains cable why?

    Just a note, First question how does the PSU deliver current to the load ? is it 50/100Hz (60 120Hz) or can the load demand in short bursts? If it is short burst and at highish speed lets say 100uS at 20V RMS into 4Ohms how does the bridge rectifier and the mains top it up? Does the 50Hz take 10...
  8. ColinWonfor

    LED Colour

    I have been asked to do a M50 with a white light, I normally use green. What colour is the most relaxing and which colour is most liked.
  9. ColinWonfor

    Health Check

    Hi All, Is everybody in good health? It has been shit here in Lock down and in London, all my hospital visit have been cancelled and I miss my nurse Maxine and her coffee. Well today St Barts hospital near St Paul.s in the centre of London have asked me to come in, I am worried I hate trains...
  10. ColinWonfor

    A new type of pot/volume control

    Well now forced to stay indoors and my pit I can do some R&D work so first project is a volume control using optics. It will allow us to have any value and multi channel pots at any pre-fixed value i.e. 10R-1000MR and either Log/Anti Log or Linear well any curve you want basically. The track...
  11. ColinWonfor

    Malcolm Steward R.I.P.

    Today at 10.00AM my poor friend and great Hi-Fi critic died after a long illness. My deepest sympathy go out to his wife and children. Malcolm was involved in a car crash a few year ago which left him bed bound. Malcolm gave me as Inca Tech and Dreadnought and Magnum and TQ some great and...
  12. ColinWonfor

    A modified theme. For the Hitachi/Maplin power amp

    This is based on the Maplin/Hitachi theme these board are stereo and use much better and rugged FETS. The PCB is stereo and you build it, It gives 100W RMS into 8R Each PCB blank will cost £40 it is double sided 2oZ Cu with silk screen. A modified theme. For the Hitachi/Maplin power amp | SECA
  13. ColinWonfor

    A question on Wigwam about TQ cables.

    XLR listening test into ATC 40 actives A question on Wigwam about TQ cables. 1) Firstly TQ cable is not made with ferro material in the plastic , as this would grind down the tooling a would cost TQ to much money, and also I have done the experiment it would be the wrong magnetic material (to...
  14. ColinWonfor

    M50/s Pre amp Line in and a DAC

    Input 1 DAC. 3 Line, Output 2 Non Balance Pre. 1 Balance Pre, SECA HP Again supplied with cct and BOM. Cost £100 + P&P
  15. ColinWonfor

    50W based on the Q20 design Power Amp

    This project for DIYer is based on the Q20 circuit but it can give you power level greater than 50W. The top PCB is the Power Amp you get 2 off these the bottom PCB is the split psu board for the power amps, the 2 circuit boards are toys for the kid and are a FM TX low power device. Again it...
  16. ColinWonfor

    No More Semelab Audio FET's for Inca Tech Claymore's

    No More Semelab Audio FET's Sorry Claymore fans, the upgraded Semelab Audio FET,s I used the replace and upgrade Inca Tech Claymore have stopped production. I have enough to complete the upgrade of the two Claymore's that I am doing now ONLY. The hopeful news is I think I have found another...
  17. ColinWonfor

    Nesting LS 25 Cables.

    A nest of LS25 speaker cables on there way to new homes.
  18. ColinWonfor

    Ophidian Speaker at Bristol 2019 Hi-Fi Show

    At the Bristol Show I met Gareth James of OPHIDIAN. The speakers he designed looked very attractive and the musical sound emanating from them was very good, This delightful pleasant young man should go far given the breaks he will need in this business. Good luck Gareth. Ophidian Audio
  19. ColinWonfor

    Glenn;s new Q20

    Thank you Glenn for allowing us to use your lovely write up on the Q20. Hi Colin That was a most unexpected phone call Saturday afternoon but a very pleasant one and it was great chatting with you . So as promised I thought I would drop you a line and let you know my first impressions of the...
  20. ColinWonfor

    Oh crap my 65th Xmas

    Merry Christmas to all from the designer and founder of EWA cables and Amplifiers and of many other products. Many of which have won awards for Colin and the associated companies now and in his past.
Top